![]() ![]() By default, this value is set to 5 pixels.Ĭheck this box to enable the ability to snap to a 2D drawing object in a DWG underlay. The Inventor Geometry Snap Tolerance in the Factory Options dialog defines the distance from the mouse pointer to the asset vertex or edge to enable snapping. By default, this value is set to 5 pixels.Ĭheck this box to enable the ability to snap an asset to the vertex or edge of an existing asset in the factory layout. The Inventor Geometry Snap Tolerance in the Factory Options dialog defines the distance from the mouse pointer to the point on the asset surface to enable snapping. The Connector Snap Preview Tolerance controls the length of the rubber band.Ĭheck this box to enable the ability to snap to the surface of an asset that has been placed in the factory layout. ![]() By default the Connector Snap Tolerance value is set to 25 pixels. The Connector Snap Tolerance value in the Factory Options dialog defines the distance from the mouse pointer to the connector to enable snapping. By default, this value is set to 5 pixels.Ĭheck this box to enable the ability to snap to connector points that are established on assets. The Inventor Geometry Snap Tolerance in the Factory Options dialog defines the distance from the mouse pointer to the point on the sketched entity to enable snapping. When snapping to sketched entities, the endpoints, midpoints, and all other points along the sketched entities are recognized to help position components in the layout. By default this value is set to 25 pixels.Ĭheck this box to enable snapping to a sketched entity that has been placed on the floor. The Grid Snap Tolerance value in the Factory Options dialog defines the distance from the mouse pointer to the grid point to enable snapping. Select this checkbox to enable the ability to snap to grid lines on the layout floor. Tip: Press F8 to temporarily disable the Snap to Floor setting when dragging an asset. Select this checkbox to enable snapping to the floor of the layout. Note: When you place an asset (or reconnect a previously placed asset) into your layout, you can press and hold Shift to pass the parameters of the asset you're placing into the existing assets you're connecting them to.Īccess: Factory tab > Options panel > Snap Types. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |